APRS<\/p>\n
To set up your IC-E2820<\/span><\/p>\n To set up your IC-E2820 & IC-E92D to use GPS (DPRS) mode you will need to create a<\/p>\n checksum code to enter in the GPS message in the 2820 & the 92, this can be done<\/p>\n by using the D-PRS Calculator <\/a> created by Pete Lovell AE5PL.<\/p>\n To set up your IC-E2820 to send GPS Data (DV-G) you need to set the following parameters,<\/p>\n MENU > DV GPS ><\/p>\n GPS SENTENCE = RMC & GGA on, all others OFF<\/p>\n GPS TX = GPS (not GPS-A)<\/p>\n GPS AUTO TX = OFF (GPS data will be transmitted when you press your PTT) This is important as auto tx can cause network jams.<\/p>\n GPS MESSAGE = (enter your checksum code created by the D-PRS calculator)<\/p>\n When your 2820’s GPS is receiving a valid signal the GPS symbol will stop flashing (this can take sometime)<\/p>\n so when you press your PTT valid DVG information will be transmitted. (note you do not need to have GB7WC connected to the Reflector to have your aprs translated to aprs.fi.<\/p>\n